Tabulum

The spiritual successor to KioskWatch. Serves as the (Cr Edge-based) client for web kiosks and web-based tracking boards.

In the Before Times™ (as I like to call them), we used KioskWatch, which handled web-based kiosks and tracking boards by automating Internet Explorer. However, since IE has been end-of-lifed we had to have a new solution.

After experimenting endlessly with controlling Chrome or Edge with the DevTools protocol, automation with Selenium 3 and 4, and interacting with debug configurations of the browser I ended up writing an application that embeds Microsoft Edge WebView2 and controls that as a single full-screen browser that can be kept on-task and even allow for some automation.

No. IE Mode is not supported in MS Edge WebView2. Neither are favorites, or extensions, or a few other features.

Since these are meant for kiosks and tracking boards only a single browser window is supported. If a page calls for a second page to open then it is intercepted and opened in the current browser window.

If a page opens two windows at once… well… that's not suitable for kiosks or tracking boards. The result is open to radical interpretation.

There is no screenshot because, well, don't you know what a web page looks like? Imagine it full-screen. Well, that's Tabulum in a nutshell.

Tabulum is Latin for tablet, table, or a collection of ordered figures. Since that sounds pretty much like what a kiosk or a tracking board is, I decided to run with it. The only regret is that it's pretty close to “Tableau”.

Tabulum was written with Lazarus 2.2.2 and compiled with Free Pascal 3.2.2. The WebView2 components for Lazarus are an open source package available for Delphi and Lazarus.

I picked Lazarus because I didn't have time to go through the motions of getting a new version of Delphi that had WebView2 components available because the time was short until this was being deployed, so I went with something I could write code in and not have to wait on purchase orders.

First, note that Tabulum is compiled for 64-bit Windows only and only functions on Windows 10 or newer. The former is to encourage people to stop using 32-bit images and the latter is because of requirements for WebView2 components.

The application's configuration is stored in a file called Tabulum.ini. If a path is specified on the command line when the program is started, it will look for that file as the configuration file. If that is not found, it will then check the program's directory (normally C:\Program Files\MHHS\Tabulum), and if not there it will check the common app data folder for the application (normally C:\ProgramData\MHHS\Tabulum). If it cannot find the configuration file it will exit after not being able to load configuration information.

==

Tabulum is pretty straightforward. To test that Tabulum is working properly, configure it to load your favorite internal site and make sure it's an allowed site as per the configuration. If it loads when you start Tabulum, everything must be good!

Installation of the app requires that MS Edge WebView2 components are installed from Microsoft.

Manual installation is not really necessary; there's a handy package that installs the files.

Place all these in a single directory, configure the program as above and run it. If properly configured, it should work fine. The user profile directory is made automagically.

This is the first public release of Tabulum.